[ale] Anyone know how to compile Xfree86 4.1.0?

[byron at cc.gatech.edu (Byron A Jeff)]

> 
> I recently built 4.1.0 on a fresh RH 7.1 system.  The build took about
> 80 minutes on a 650 MHz PIII and when it finished, there was about
> 625 MB in the build tree.  There were no major problems but don't
> forget to do an ldconfig and restart the font server, etc.

Well as I should have done from the start, I finally got around to reading 
the INSTALL document. Basically it's as simple as editing the site.def
document in the config directory and doing a 'make World'. Took a couple of
hours on my older machine. Also I had a couple of bugs from the patches. But
it did compile and it works. The only thing I'm left with is trying to get
both copies of X to run at the same time.

BAJ

> 
> Byron A Jeff wrote:
> > 
> > I've run across a patch that adds USB keyboard support and removes virtual
> > terminal support. A combo which in theory could enable two complete stations
> > from one machine. Check it out here:
> > 
> > http://www.linuxplanet.com/linuxplanet/tutorials/3100/1
> > 
> > But this is my first time trying to compile an Xfree86 server from source.
> > Has anyone done this. Any caveats I need to look out for?
> > 
> > I'm testing out my Slackware 8.0 install, so I'm not sure what if any
> > distribution info you need.
> > 
> > Any help would be appreciated.
> > 
> > BAJ
> 
> -- 
> Robert Stickel
> rstickel at connex.com
> 

--
To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.