[ale] EQL

[jfondow at sprintmail.com (Jonathan)]

Hello all,

I am trying to use 2 analog modems to dial back to work and then bond
them for one pipe of throughput.  Here is some info.  I am using two
analog modems to dial into a Cisco 2510 with pppmultilink on the two
dial-in interfaces.  I have eql built into the kernel and here is the
commands I have used:

ifconfig eql <local ip> mtu 1500
eql_enslave eql ppp0 24000 (slow connection)
eql_enslave eql ppp1 24000
route add default eql

When I get both lines up, then I telnet to a server (AIX) and have to
throw a display back local: xterm -display <one of the dial-up
ip's>:0.0&.  Then when I do an ifconfig it shows all the traffic going
through the interface that I had to put in for the display.  My question
is how to get the connections to act as one.  Is there something else I
need to the router?

Now that this is clear as muddy water, any help would be greatly
appreciated.  I am very new at trying to set this up.

SuSE6.1, kernel 2.2.9